well that was fun to read through lol
but in all honestly @
ChrisV you telling @
simpleisbest to "stop acting and saying that you know anything for certain" goes both ways. unless you are a rep for koni or the engineer who was in charge of the design for the koni full replacements, then by all means go ahead and preach that the koni is an exact 1 for 1 OEM replacement.
however in the end, it doesn't matter if the variances are off by 1mm or even 1 micron since now you are getting a competitive advantage.
in my eyes you guys both don't know so you guys are both entitled to your opinions
just my 2 cents.