Quote:
Originally Posted by erok81
I am that point now. Looks like you just notch the crash beam for the ic outlets and then drill a couple holes on the underside of the crash beam.
|
That's right, mark where the intercooler inlet and outlet would go, take off just what's needed and then drill some holes where the mounting tabs fall on the crash beam. I'm going to post some pics in a bit from my install thread.
@
drambo136
Check out this thread, first post you'll see a few good pics of the cutting areas and how to mount. Notice the crash beam on the passenger side has a square hole right in front of the intercooler coupler, I had to cut this open to reach the nut for the bolt secure the intercooler mounting tab, the driver side already has access.
http://www.ft86club.com/forums/showthread.php?t=81623
__________________
GTX2867R, moto-tuned , tomei op , motiv fp , Invidia Q300 ti , Rota titan 17x9 +42 , nt555 255/40 , ST coilovers w/cascam , Hotchkis sways