View Single Post
Old 06-12-2015, 01:46 AM   #10
serialk11r
Senior Member
 
Join Date: Mar 2011
Drives: '06 AM V8V Coupe
Location: United States of America
Posts: 5,279
Thanks: 285
Thanked 1,075 Times in 759 Posts
Mentioned: 13 Post(s)
Today's update:

Redline MTL in tranny, Motul 300 in diff. Here's the car on the lift at the shop:


Shifting is way smoother with the fresh fluid, but 5th/6th are still kind of notchy and the gear chatter is still annoying, but the shop owner said his BRZ does the same thing so :/

Project nerf-that-rattle has officially started:

The driver's side latch on the rear seat has a little bit of rattle, I put these vinyl stick-on door bumps onto the plastic trim clips to give the rear seats some pressure against the latches. If I wiggle the seat it still rattles, so I added electrical tape to the latch. I may need to switch that out for aluminum tape.


Door switches rattle like crazy, but I'll use some foam tape on them when I get my side windows retinted. BTW 3M Crystalline 70 is amazing stuff, but I'm thinking Llumar Air 80 on the side windows to save a little money because most of the heat comes through the windshield anyways.

Passenger seat rail latch sliding adjuster thingy fix:

Cut a piece off one of the PVC stick on bumpers to make it thinner:


Somehow managed to stick it onto the metal tab that blocks the rail (the passenger side adjustment handle has a second bar that's actuated when the seat back is all the way forward, but they chose the same springs to hold the heavier bar up so it rattles):


My hands are pretty big so it was a very very tight fit under the seat lol.

Another thing I picked up today was a 1.25" PVC plug for the soundtube. I had been using a 1.5" rubber cap like one of the tutorials described but I don't feel good about putting a soft rubber cap over a rubber tube! The plug goes in too tight so I sanded it a little and painted it black to match:
Fitting painted black:


Installed:


Finally progress report on the tailpipe sanding, as you can see there's still some places where it's pitted that I haven't sanded the rest down to yet :/ I need to pick up more low grit sandpaper.


Next installment will be exhaust hole cover, followed by OFT tweaking and LED installs next week (just bought replacements for every single incandescent bulb on the car minus the high beams ).

Last edited by serialk11r; 06-12-2015 at 04:24 AM.
serialk11r is offline   Reply With Quote