|
I'm a noob at mods and I installed the N1 all by myself.
I used WD40, ratchet and spanner.
I put the car up on self made wooden/brick ramps. The most difficult bit is getting the OEM exhaust off the rubber brackets that hold it. That's where you need WD40 and to push the brackets/mounts side to side to losen them up.
Everything else is pretty easy to figure out. I installed the N1 in sections, losely connecting them to the hangers and each other before aligning them and torquing them up. You have to re-use the OEM gasket and bolts/springs that connect to the cat (the very front of the section you'll be working on).
I would advise having a 2nd person to help you, but it isnt necessary.
|