Quote:
Originally Posted by aschnell
So i picked one of these up. Got it for the weekend to have time to install. Header looks nice, got it with the cat. Install went fine except the time I wasted with the stock heat shields. Used a crows foot for the middle nuts, couldn't get a socket on them.
Couple of notes.
1. It does NOT fit the stock heat shields. I asked this specifically because I saw mention of it probably in this thread. They told me they would fit after I specifically asked again. Not even close. Wasted my time testing that, going to have to have a chat with the afe guys on that one. They thinking of the skid plate? I feel a little misled. Might have gotten a coated header instead.
2. Front O2 sensor cable ends up a little short. There are two stock cable tie mounts, had to leave one off to keep the cable from being pulled too tight. The rear ends up longer than necessary, but both are ok.
3. Sound. I still have the under tray off so I could drive it and then retorque the fasteners. To me sounds pretty much stock, that's what I wanted. Driving around with the windows down I hear a little more noise but the skid plate is off still.
4. Performance. I have an oft. Also just put in an afe dry panel filter at the same time. Stock otherwise. Running stage 2 93 el tune. Wanted to reduce the torque dip mainly, and I am happy with the end result so far. No dyno, just feel so far. Engine feels much more linear.
|
Well after I recieved your PM, I went to do some further digging myself. I apologize for the misinformation. Unfortunately there was some miscommunication among the team, and I was told differently. I went straight to the fabricator, and he confirmed to me the covers do not fit.