Since I haven't done any crazy stuff in a while... So I am really in love with the Project Mu color for whatever reason. Finally getting some pads, already have the fluid (though not running it till I burn out my Motul), and when I get out of law school and have an actual paycheck maybe I'll run those forged calipers. Got a lot of their tiny lil' products too.
I am also super ADD (also in the medical sense) about colors and layouts, etc. So this week I was wondering, "I wonder if that color would look good in/on the car?" Today, I started to answer that question.
I am in the middle of some "investigative learning", as shown. I'm gonna redo the PWJDM nuts individually, though likely in a contrasting color. Maybe the orange? I run those braided hose covers since the PWJDM strut brace rubs hard into one of the hoses, and just one little section looked janky so I braided the whole thing, then figured both looked better.
Still a few more pieces to go, but it matches the PMU color almost 100% (I have samples to compare). It's ceramic engine paint too, so 500F safe!
I'm sure this won't be everyone's particular cup of tea, but then again I would literally rather buy a stock FR-S and be forced to leave it stock than get a free stanced one (any configuration you can imagine) and have to keep it stanced.
