[CSG Mike]

Originally Posted by 7thgear

might as well post a problem I've been having since the beginning but generally too lazy to address.


So, I use my SOLO for autocross. I start each morning by creating a new point-to-point track, I create a start beacon and a finish beacon.


now, my problem is that the recording never starts at the start beacon, but when I hammer down above a certain RPM.

ive dinked around inside the settings, and there's one for RPM/speed launch, but I'd really want it to just activate upon triggering the start beacon. Any help?


second issue is that after finishing an autocross run, the logger starts a "second lap" even though I'm no where near the starting point, and it runs until I park the car.

not a big deal, but just forces me to clean up the files manually at home, but would love it if it just sorta did what I wanted it to do. Start at start... finish at finish, log a file.

What mode is your unit in? If you're not in circuit, try lowering the S/F tolerance distance. Also, lower the recording start window.