General question here about bad flash a while back.
Basically went to flash like normal and it failed, don't recall the error and can't find the full log but I left the ignition on and only hit write again. It worked but I got the following error on the second write attempt. I assume it is because the first failed write erased everything?
Code:
[11:46:29.509] reading vehicle info...
[11:46:31.514] OBDII communications failed - trying OEM bootloader...
[11:46:31.515] connected to OEM bootloader!
[11:46:31.515] preparing to write area 00008000-0013FEFF...
[11:46:31.517] erasing area 00008000-0013FEFF...
[11:46:37.110] writing area 00008000-0013FEFF...
[11:48:15.121] interface close
Did I avoid a brick by leaving the ignition on and just doing another write? Or is ecuflash smart enough that it would just been able to write the ROM again regardless of what I did with the ignition?