Quote:
Originally Posted by Kodename47
Place the top code with the addresses in the upper part of the definition and the part where it says table type =2D with the rest of the DBW stuff of the lower half of the definition. You'll see that the definition should be in 2 distinct halves, with a separation phrase in the middle.
|
ok i got the table working thanks.
now if my requested tq is higher then my torque base say 207req/ 200base i get a 1.035 such as the stock maps are. That should be using the 1.0 raw ecu value from the target throttle position table since thats the max, but thats set to 102.4 stock and the throttle body is open only to 90%.?? There is somthing i dont understand here, do the calculated tq tables come into play?