Quote:
Originally Posted by Kodename47
These should work:
Code:
<table name="Requested Torque Base" storageaddress="13C528">
<table type="Y Axis" storageaddress="13C4CC" />
</table>
<table type="2D" name="Requested Torque Base" category="Drive-by-Wire Throttle (DBW)" storagetype="uint16" endian="big" sizey="23" userlevel="1">
<scaling units="ECU Value (Raw)" expression="x*.0078125" to_byte="x/.0078125" format="0.0" fineincrement="1" coarseincrement="10" />
<table type="Y Axis" name="Engine Speed" storagetype="float" endian="little" logparam="P2">
<scaling units="RPM" expression="x" to_byte="x" format="#" fineincrement="100" coarseincrement="1000" />
</table>
<description>This map is used to calculate the percentage of maximum torque.</description>
</table>
|
hm nothing is showing up. i tried it near the dbw codes and at other parts.. no new table showing in any menu