View Single Post
Old 04-13-2015, 02:40 AM   #182
SoCalArgento
Senior Member
 
Join Date: Jul 2014
Drives: 2014 Argento FRS
Location: 805
Posts: 262
Thanks: 67
Thanked 25 Times in 23 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Garage
Quote:
Originally Posted by JDsThatGuy View Post
I don't drive my car much since I work from home, only really drive to the gym or grocery store during the week and then a bit more on the weekends. How much driving do you do to get back the response in a week or two? If you do a lot of driving and it takes that long then I'm thinking I'll flash back to stock and then reflash stage 1

When this happened to me I just re-flashed the tune I wanted and followed these steps :

Turn ignition fully off after a flash or reset
Turn ignition fully ON, do not start car, do not touch throttle, leave for 20 sec this will allow ECU to perform its diagnostics and calibrations on cam position and throttle position sensors
Turn off ignition
Turn on ignition leave for 20 sec then start car do not touch throttle
Let car idle for at least a minute and wait till it settles at the normal idle of about 750 RPM, again do not touch throttle.
After normal idle is achieved then drive car.

after I followed above, it seems to have helped a lot. Not sure if this was just me thinking it helped or if it actually worked so YMMV.


Sent from my iPhone using Tapatalk
SoCalArgento is offline   Reply With Quote