Quote:
Originally Posted by Fizz
Its terribly difficult to replace them without removing the elbow, but it can be done with lots of patience and swearing. When I replaced mine to brass fittings, I simply snapped off the plastic fittings (helps when the weather is cold) then unscrewed the remaining piece.
But I found it next to impossible to screw in the new 90deg barbed fittings. Instead, what I did was get 2-piece fittings to make it 90deg. If that makes sense.
And get a set of crow foot wrench....it'll help massively.
|
This is pretty much what I figured I would do. But out of curiosity, is it terribly difficult to remove the elbow and put it back on? Which Loctite is used on the bolts and anyone know what to torque the bolts too when putting it back on? Sorry if this is answered somewhere earlier in the thread.