Quote:
Originally Posted by DocWalt
Neat, I just ran through the process on that. Thanks! That should let me kill the AFR dip and spike after I get some fresh logs with the tweaked scaling. Hopefully I see some good results from that. Not sure what it is in my setup causing the dip and spike, but ok.  |
To make sure you're getting good results I would ensure adjusting after multiple logs rather than by each log. Delete out the run data (error and count) I left in there, I only used that to test it. You may need to correct your table load axis of you're having specific issues as reducing the range to 20% will Remove data too far away from the axis values to ensure the table is accurate.