Quote:
Originally Posted by awhatzable
So if I press on the sensor, circled in red. The gap between the 2 blue circle will close up itself ? Is the sensor suppose to be some button that depresses when you press it ? or do I just push it while lifting the clutch pedal to close the gap where the protruding pin is ?
Also, the nut around the rod is 17mm & when I try to twist the rod around the 17mm nut the clutch pedal doesn't descend. Am I looking at the wrong nut or is my car different due to it being sold in a different country ?
This part is confusing me  |
What Doc said.
The rod just spins in the master cylinder. It is CRITICAL that you get the switch adjusted properly so it allows the master cylinder rod to fully extend. I suspect pump-up due to improper adjustment is the reason some people have had clutch slippage issues.