Quote:
Originally Posted by Churg
I only had one new bolt for each side, not two. I was told by the previous owner to reuse one of the bolts from the stock setup. I might've mixed up which bolt went on top and which went on bottom. It's allllll starting to come together now.
Unfortunately, I won't have access to a jack until Friday.  |
I haven't installed the SRCs in awhile (Mike has been doing the work...hehehehe). The top hole should be slotted and I believe TEIN provides a "bushing" that fills in that slot when you install the bolt. Either way, -3.x should not be an issue. If there's still an issue, West End has done a few alignments with the SRC installed BRZ/FRS so they can help diagnose that issue for you. Might cost a little extra, but they are fast and efficient. All their measurements have been dead-on every time so when you can, make that appointment!
