Quote:
Originally Posted by ST-A
yes we have the 700G rom and i started from the OFT stage2 EL 2.063
I'm using romraider to tune
i just changed the map sensor scaling in 1 place , didn't find other places? can you guide me to where they are? i changed the "manifold pressure scaling" under the "manifold pressure sensor" tab.
i also rescaled the fuel and ignition maps to 2.25 in the load scale.
DI injection maximum is now 100% in the full map and GDI pressure target is 20Mpa above the 100 on the load axxis.
i use the Toyota techstream program for logging.
|
Do as @
steve99 said and check the actual ROM you're using. It still worries me about your DI/PI settings, using 0 in the Pi ratio means that you're using 100% DI for fueling percentage and not using the PI at all. 100 would mean no DI at all. Either of those would mean you would hit 100% duty for the respective system causing your issue. You also would need to adjust the max DI volume tables. I know ECUtek recommend no higher than 1.3ml, that may still be high but may see further fuel be available.