Quote:
Originally Posted by ST-A
i rescaled map sensor to the values given to me, it is the denso/honda map sensor i'm using, the same sensor they use with the ecutek kits.
my maf limit max is also 500
my maf scaling map just goes to 315 right now, i have not seen values over 300 yet.
engine load limit max is set at 4 g/rev
i did not convert the rom or xml to metric values, i'm still using the xml that comes with the oft 2.063 package (2.07 ZA1J700G)
how do i convert it to metric? adjust the whole XML file?
|
@
Kodename47 did some ZA1JA01G metric definitions here.
http://www.ft86club.com/forums/showp...&postcount=333
If your using an OFT ZA1J700G tune file its highly likely its actually a ZA1JA01G tune calid adjusted to look like a 700G.
You can check this with a hex editor
Open the tune file with a hex editor search for string ZA1J their will be three occurrances in the rom usually all are the same but in oft roms if its been calid adjusted the first two occurrances are the psuedo calid and the third instance is the real calid .
If the real calid is A01G then just change the xml files names and the calid in the xml file to 700G, and use kodename47 A01G metric defs with a lot of extra tables identified in them.