View Single Post
Old 02-20-2015, 06:40 AM   #27
steve99
Banned
 
Join Date: Dec 2013
Drives: FT86
Location: Australia
Posts: 7,996
Thanks: 1,035
Thanked 4,992 Times in 2,983 Posts
Mentioned: 598 Post(s)
Tagged: 2 Thread(s)
Quote:
Originally Posted by dave- View Post
Blasted air through the front pipe and muffler with the compressor, got a lot of particles which were probably remnants of the OEM header cat. Haven't decided on what to do with the header as yet but we replaced the over pipe (flange was warped) which fixed the exhaust leak. Obviously it threw the P0420 CEL after about 30mins of driving but not concerned with that right now.

Car has OEM A01G tune in it with no alterations. Did 2 log sets:
http://datazap.me/u/dave/stock-oem-a01g-tune
http://datazap.me/u/dave/stock-oem-a01g-tune-pt2

I know the OEM tune had some minor knock on our fuel so I'll flash the OFT V2 Stg1 A01G T K S 98 ROM to start with and do another set of logs tomorrow as a baseline.
performing inline with stock tune by the looks of log bit of knock and iam around o.8.

just disable the p0420 code in the T K S 98 TUNE as its for catted header so not disabled.
some guy on this forum just cut and welded a pipe where the cat was to make it flow better than a gutted cat. Aparantly it performed pretty well on par with catless header.
sinceyou likesound of stock header probably an option then just run the CatlessEL header tune and make timing andtemp compensation mods similar to the tune above.

should work fine and cost sod all.
steve99 is offline   Reply With Quote
The Following User Says Thank You to steve99 For This Useful Post:
dave- (02-20-2015)