View Single Post
Old 02-19-2015, 08:12 PM   #2
Kid90
Ball Bearing Turbo
 
Kid90's Avatar
 
Join Date: Feb 2015
Drives: 2013 FRS 10 Series
Location: Tropical Islands to the Desert
Posts: 51
Thanks: 0
Thanked 10 Times in 8 Posts
Mentioned: 0 Post(s)
Quote:
Originally Posted by Musickmixxer90 View Post
Anyone know of any tuners who have done FI or any kind of other tuning on our cars before?
yes, Munkywurks Garage, has done it already

Its not too hard to do the swap yourself, depending on the turbo/supercharger kit its pretty much a bolt on affair. I have personally seen and helped install a Full blown Turbo Kit onto a FRS.

http://fullblownmotorsports.com/full...base-turbo-kit

The Full blown kit seemed to be a tight fit, needed some small cutting for room in certain areas. If you have a basic tool set, handy with fixing cars, then this is something you should be able to do with minimal difficulty. Make sure to get with the turbo kit, cooling upgrades such as a bigger radiator and such.

The most important thing is getting your FRS/BRZ *TUNED* after installing the kit. I recommend getting an ECU first or purchase it at the same time you purchase the turbo kit. Personally I have seen and experienced the importance of a car that is tuned with a standalone ECU thats boosted vs one thats not.

You don't want to spend all that money on a turbo/supercharger kit and blow the motor.

sorry for the long answer hopefully it helps

Last edited by Kid90; 03-04-2015 at 05:43 AM.
Kid90 is offline   Reply With Quote