Quote:
Originally Posted by Chimera
that's good too, maybe print a small cheat sheet and keep it back there incase 5 years from now you look at it and go, "now what did I do here?"... which I have done before.. haha
|
Yepp thats what I was thinking. Either that or I could use colored heatshrink, or I could just trim all the wires real short and solder on the proper colored wires. Yes, I hate these pins that much...
Quote:
Originally Posted by Porcupint
Ugh..reading that makes me cringe so hard I want to just re-pin it for you and mail it to you.
|
I'd give you $10 to 10002? lol
Quote:
Originally Posted by B-R-Z
The Metra harnesses are easy to re-pin while a Chinese harness that came with my Android HU was nearly impossible to get the pins out. Very frustrating.. I had to resolder one or two of the pins back onto the wires.
|
This is what makes me want to try again with a harness purchased elsewhere. The harness I got this time was not in any packaging at all and the ends of the wires weren't pre-crimped like I've seen in most pictures here. Makes me wonder if I just had bad luck and got a shitty harness. Cause its not like I dont know how to remove the pins, some just freaking refuse to come out even though I SEE the retainer clip pushed all the way up and against the top of the connector =.=