02-09-2015, 12:06 AM
|
#2
|
|
Senior Member
Join Date: Sep 2013
Drives: 2013 FRS
Location: SF, CA
Posts: 2,629
Thanks: 1,055
Thanked 5,470 Times in 1,494 Posts
Mentioned: 605 Post(s)
Tagged: 9 Thread(s)
|
Quote:
Originally Posted by momo3605
Hey guys,
I loaded the tune successfully and took the car for a drive after letting it idle for a minute. According to the info page, I have B01C.bin, SW Verision 0132, and calibration code ZA1JB01C. This should be the stage 1 tune for a stock car on 91. Not sure if this is 2.0 or an older version of the tune.
The drive was fine, I was watching the real time data and STFT were hovering around 1-3% and LTFT mostly 0%. Which looked pretty good, also the car DEFINITELY feels torquier and the dip feels less. But my connection to my OFT came loose a couple times while watching real time data, and on the 2nd or 3rd time a CEL light came on. I stopped the car and turned it off and on again and the light was still there. Then I checked the Fault codes and it said no fault codes. Not sure what to do next! Any tips or advice? Would greatly appreciate any help!
Thanks!
|
What you experienced are CAN communication faults caused by the connector coming loose while viewing realtime data. Nothing to worry about. Although you should be able to read and clear the code. I'm a bit stumped.
|
|
|