Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Help! Just installed OFT stage 1 and got CEL

momo3605 · 02-08-2015, 11:26 PM

Hey guys,

I loaded the tune successfully and took the car for a drive after letting it idle for a minute. According to the info page, I have B01C.bin, SW Verision 0132, and calibration code ZA1JB01C. This should be the stage 1 tune for a stock car on 91. Not sure if this is 2.0 or an older version of the tune.

The drive was fine, I was watching the real time data and STFT were hovering around 1-3% and LTFT mostly 0%. Which looked pretty good, also the car DEFINITELY feels torquier and the dip feels less. But my connection to my OFT came loose a couple times while watching real time data, and on the 2nd or 3rd time a CEL light came on. I stopped the car and turned it off and on again and the light was still there. Then I checked the Fault codes and it said no fault codes. Not sure what to do next! Any tips or advice? Would greatly appreciate any help!

Thanks!

02-08-2015, 11:26 PM	#1
momo3605 Member Join Date: Sep 2014 Drives: 2014 Fr-S Monogram Location: Bay Area Posts: 48 Thanks: 2 Thanked 6 Times in 4 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Help! Just installed OFT stage 1 and got CEL Hey guys, I loaded the tune successfully and took the car for a drive after letting it idle for a minute. According to the info page, I have B01C.bin, SW Verision 0132, and calibration code ZA1JB01C. This should be the stage 1 tune for a stock car on 91. Not sure if this is 2.0 or an older version of the tune. The drive was fine, I was watching the real time data and STFT were hovering around 1-3% and LTFT mostly 0%. Which looked pretty good, also the car DEFINITELY feels torquier and the dip feels less. But my connection to my OFT came loose a couple times while watching real time data, and on the 2nd or 3rd time a CEL light came on. I stopped the car and turned it off and on again and the light was still there. Then I checked the Fault codes and it said no fault codes. Not sure what to do next! Any tips or advice? Would greatly appreciate any help! Thanks!