Quote:
Originally Posted by AceHeader-MT
But back to the point though, how much does this cost?
Header is $1100
OP (required) is $300
I'll still ask the question about ft/lbs. Not a bad thing to have for reference anyway
Sure thing.
Top curve= 4-into-1 with ACE muffler (not for sale yet)
Mid curve= 4-into-1 with muffler delete
Low curve= 4-into-1 with stock muffler
All pulls with Stock ECU and K&N air filter
The parts, photos and pricing will be listed on the website this week. We just started production today and will post photos of jigs and progress throughout.
|
What was the exhaust setup on the 4-2-1 header dyno posted in the first post if this thread?
Why is the overpipe required?
Can you post a pic of the primary merges?
I'm assuming these are stainless steel, what grade of steel are they?