There's a bolt and washer that goes on top to secure the pulley to the charger, but not sure if there's anything else on the charger side (spacer for example)... When I do secure the bolt and washer to the charger, the pulley doesn't spin since it's touching the charger base. Just want to make sure that makes sense before I re-install it today. I would call Vortech, but they are closed on the weekends...
If you are wondering why it was removed... I had the charger checked out and it needed one new bearing and shaft seal.... the re-builder removed the pulley in question... and hence, my question since the pulley is pre-installed by vortech when bought new.
Edit 12/7: There's a bearing that goes between the pulley and charger that I didnt realize was in the return box... everything is reinstalled. The pulley does spin as it should
