Quote:
Originally Posted by Perth-86
G'day Wayno - Brand spanker from the US tho there wasnt a protective screen on the unit which made me think it might have been used before?
Purchased direct from US via OFT webpage
Connection was secure I am pretty sure as it went through the steps (ie - Switch on ignition etc)
I am slightly worried about the stock rom, since trying the OFT I have the check engine light and my car doesnt do the autoblip in manual mode.. (again might be a side issue)
Will investigate the newer software right now!
Cheers guys
|
ARRRRH do you have an existing ECUTEK tune.
Ecuteck tunes are locked and will not allow other devices to read.
You need to load a stock rom back to your car , or at least the ecutek stock rom back to car before oft can read your rom.
you may also loose your ecutek licience as its embedded in "stock rom.
although the OFT will write back your stock rom which will have ecutek licience info in it.
if you don't have ecutek tune ignore above.
the oft will clear / read the cel code although its probably just a can buss transmission code cause when you plugged in oft.
just use oft to clear cel codes all should be ok.
just select toyots zn6 first.