We recently tuned this BRZ with a PTuning Header, making peak 200whp on 93 octane fuel for a 40whp peak gain (Stock BRZ/FRS's run at 160whp/138wtq on this dyno)!
Setup:
2013 BRZ 6MT
- PTuning EL header
- Nameless Performance 2.5" Catted Overpipe/Downpipe
- Perrin 2.5" Resonated Cat-Back Exhaust
- TRD panel filter
- 93 Octane Pump Gas
I would have been surprised by the existence of the torque dip had I not seen the dyno charts from PTuning as most aftermarket headers I've tuned remove the dip. But, like the stock header, I was able to minimize the dip with the tune to the point that the dip is not felt at all running through that area at part or full throttle.
Great mid to top-end power, and very smooth!
Tuned with EcuTek RaceRom by Circuit Motorsports
- Tuned by Bob