We just revamped our
service section to better reflect what we do. Not only have we also hired a fabricator, but we have a total of 3 lifts now to include...
Alignment & corner balance!
The lift is bolted down as is the camera column, this week we will hang the rest and run the plumbing and get it finished up. This is a hunter optical system, so it is super accurate and we have extension ramps for lowered cars.
We also have Intercomp scales to do the weighing, photo dump will be forthcoming once we get everything set up and cleaned. Place is a mess from all the moving and concrete drilling to fit the Hunter rack.
All the special order Hipermax coilovers sold quick, but we have the following used parts available:
Eibach front sway bar
Hotchkis rear sway bar
Perrin front pipe, over pipe
Speedfactory dual 2.5" cat back exhaust (black)
H&R Coilovers
Raijin 18x9.5 square black
RPF1 18x9.5 black (one has slight curb rash in a small corner, but can easily be covered up)
We can powdercoat the wheels to whatever color for about a 100 bucks, this includes clear coating! If you haven't seen clear over powder, you're missing out, gorgeous finish.
Pricing is basically 30-50% off list for these parts, all are in good working condition but clearly have about a year's worth on them.
In the FI front we have JRSC kits available for same day install (one arriving next week) and have ONE sprintex 335 kit destined that isn't spoken for yet. This is for those who want 300
torque. Think LS type of power. For locals we can cut a bit of a break because we REALLY want to see one of these on a stock motor. No guarantees, but if anyone can make it work it would be us!
