Quote:
Originally Posted by Fizz
Sorry I'm still somewhat lost on how to physically connect my AEM wideband sensor and gauge. Please be patient because I'm really dumb when it comes to wiring up electronics 
I've got the AEM Digital UEGO AFR gauge (non-failsafe), and I'll be installing it in place of the factory rear 02 sensor.
But what I'd like to know is, how do I wire it up?
a) snip the stock sensor wires from the connector
b) fit the AEM sensor into the factory rear 02 bung
c) connect power and ground wires
d) join the AEM's 0-5v analog output wire to the blue wire off the factory connector
Is that correct? And will that allow my tuner to tune (using ecutek) accordingly? I don't have an electronic boost controller. |
This is a question best asked of your tuner. There are only so many wires or methods or getting an aftermarket signal into the ECU. It sounds like you have the basic idea though. I wouldn't cut the entire connector off. Go up stream of it a little and just cut the signal wire. You can get power and ground from inside the car.