Quote:
Originally Posted by mla163
It's a little hard to get super precise on an alignment rack. It may read at 0.0000" toe, but there is enough play in suspension bushings, etc that you might be good for 0.0x" toe. Same with camber.
Measure with a ruler, mark with chalk, cut with an axe.
|
A skilled tech can get it dead on, every time. This is what sets aside someone with a "good enough" mentality and a "perfect" mentality. The amount of time it takes to get "perfect" is the same as "good enough", if the tech is talented and cares enough.