View Single Post
Old 09-24-2014, 04:58 PM   #14
Circuit Motorsports
Senior Member
 
Circuit Motorsports's Avatar
 
Join Date: Jan 2012
Drives: 2013 Subaru BRZ
Location: Orlando, FL
Posts: 4,353
Thanks: 294
Thanked 495 Times in 259 Posts
Mentioned: 35 Post(s)
Tagged: 2 Thread(s)
Send a message via AIM to Circuit Motorsports
Rally GT86 Tune Update

We completed our initial tune on the Rally GT86. This tune was performed via a remote dyno tune.

Tune and Engine Setup:

Setup:
K&N Intake
Nameless Performance 4-2-1 Header with 2.5" straight pipe
TODA racing big throttle body (may be coming off)
TODA racing lightweight flywheel
TODA racing lightweight pulley kit

Running 98 RON gasoline

Top Speed on flat Tarmac: 142mph (5.13 FD installed after tune)



The dyno used is a Dynocom dyno.

Note: The pre-tune results were with all of the hardware installed running the factory tune.

These are the results from the initial tune. We did not have much time to get the tune fully dialed in, so we'll be fine tuning it in the near future.



What really impressed us was the 75+ lb.-ft. torque gain in the stock dip around 4200 rpm. With a tune, the nameless header really shines!

Read more about this GT86 Rally car and the Rally race it is competing in now here: http://www.ft86club.com/forums/showthread.php?t=74777

- Bob

Tuned using EcuTek RaceRom by Circuit Motorsports.

Last edited by Circuit Motorsports; 09-26-2014 at 10:49 AM.
Circuit Motorsports is offline   Reply With Quote