So, was working on my install last night.
A couple of notes so far:
- Instead of drilling holes for the braided stainless lines up front, I just routed them along the brake lines into the engine compartment. Clean and easy.
- As was already mentioned, I ran the wiring harness through the Sound Tube firewall penetration. In my case, the Sound Tube was already disconnected, so no big loss.
- The fuse tap I received with the kit is too big for the APS Style (micro) fuse that was recommended for use. I'll pick up something more appropriate.
- At this time I haven't exactly decided where I'm putting the controller, so it will be in the center console for now, no holes drilled yet.