09-09-2014, 12:02 AM
|
#53
|
|
Senior Member
Join Date: Dec 2012
Drives: FR-S Whiteout
Location: California
Posts: 2,863
Thanks: 1,808
Thanked 791 Times in 611 Posts
Mentioned: 42 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Originally Posted by JB86'd
The other day I lost and gained connection a few times in quick succession, and my car threw a U0xxx code, and my tachometer was stuck around 6000 rpms, with the car off, started the car and it stayed there..so I turned the car off and cleared the code with my Scangauge, since the OFT said no codes. I then disconnected my battery and reset my ECU and all went back to normal. Just about shat myself though. Found out my OBD2 port was bad, got a 30cm extension cable and all is good.
Anyways, to disable this from happening again I'd need to modify the map in romraider and reflash?
|
Yup had that happen many times as well. CEL on and OFT detects no code.
|
|
|