[Foobar]

You have to connect the amp remote turn on wire from the HU to pin 9 of the 10 pin harness (I cut off the SWC wire from the HU's 10 pin harness, connected it to the AMP wire, and moved the pin to 9) and you have to Repin the aux wires on the swc harness you linked (I haven't done this one yet).

If you have a reverse cam, you have to wire the reverse wire to pin 2 of the 28 pin harness, and get power to your camera from another source than the stock HU (can apparently use the same pin 2 to do that as well according to one member in this thread). EDIT: Confirmed, I just hooked up my reverse cam. I tapped the BACK wire from the HU to pin 2 of the 28 pin harness (Orange/White) and I went ahead and tapped the power to my camera to the same lead so that it was only getting power when reverse was engaged. Works a treat.

That ought to make it all plug n play.

Sent from my Nexus 5 using Tapatalk