[Turbowned]

Just got back from a week in Germany (and renting a GT86 to drive on the Nurburgring which was epic!!!) and some more parts came in: OMNI 3bar MAP sensor, Venair silicone radiator hoses, AEM wideband O2 sensor with failsafe, HKS air inlet duct, and a Tomei Expreme equal length header. I need to send the header to Swain Tech in NY to get ceramic coated so that will be another week. That makes the following parts for the build:

-Vortech H67B supercharger tuner kit
-Vortech 3.125" pulley
-DW65c fuel pump
-AEM wideband O2 sensor
-OMNI 3bar MAP sensor
-Koyo aluminum radiator
-Venair sport silicone hoses
-Perrin oil cooler
-Perrin lightweight crank pulley
-Perrin lightweight accessory pulleys
-Tomei Expreme equal length header
-Snow Performance water/methanol injection kit
-HKS air inlet duct

That leaves just the ECUtek cable/license, installation and troubleshooting (if any), and the tuning. After this I want to get a lightweight flywheel and heavier duty clutch, carbon fiber driveshaft, and then move to further suspension mods.

Hoping to get everything installed by the end of the month.... *fingers crossed*