Quote:
Originally Posted by ATL BRZ
Looks good. How did you mount those to the arms? I see they have tabs for screws on the back of them but I'm not sure you were able to use those.
|
Thanks ATL BRZ! I just used 3M automobile attachment tape across the face of the control arm as well as under the taps that rests on top. I originally planned on drilling a couple of holes to run cable ties through as well but it's surprisingly secure as is. I suppose someone could drill a small hole for a screw or bolt without compromising the integrity of the arm.
Here's a picture of the back of the scoop while I was mocking up the tape placement. The tape I had wasn't wide enough so I ran two strips and cut pieces for under the tabs.
I went ahead and installed a couple of cable ties just for good measure.
