Quote:
Originally Posted by Malt
If everything gets anodized black then I'll probably be one of the first customers. I've been a bit hesitant to add these because the splitter by itself is already a bit much for a "street car" and adding ties only adds to it. Keeping it discrete where possible is a huge plus in my book.
|
We aren't big into standing out either. These splitter ties will be as discrete as we can be, while being economical enough that people will hopefully be able to purchase them. The rod ends just cannot be anodized economically.
Quote:
Originally Posted by Malt
What is the plan for those that ordered the first version and have no marks for where to drill for these and the additions to the bottom? Also, how far down does the turbulence generators extend down from the bottom of the splitter. I'm already low enough and I'm semi worried that going any lower might mean more scraping.
|
We are going to print out a sheet of that will be full scale of the splitter. This should allow you to get within a 1/16 of an inch of where they need to be. They hang down another 1/2", if you are scraping them, you will be scraping other chassis/suspension/engine components.