Quote:
Originally Posted by jonbonazza
I have never reset it manually. Unless unplugging the battery will do so... In which case about 2pm today. Haha
|
Removing battery terminal will reset ecu and clear DTC/CEL codes as well as reset learned fueling and ignition timing parameters and a bunch of other counters.
listen to @
nelsmar you need to get some logs of general driving to see what going on.
as nelsmar said AEM intake will require MAF rescale or you could get problems and CEL codes you describe was it installed after tune ? also leaky exhaust gaskets near either 02 sensor or engine can throw readings off and cause rich/lean issues did you use new gaskets when headers installed if you re-use the originals they tend to leak after about a month. ??
If you can't do propper logs (torque is a bit slow refresh rate and cannot log all the required parameters) take it back to tuner before it gets worse and more expensive.
If it was me I would not be going WOT with that cel code coming up.