Quote:
Originally Posted by Circuit Motorsports
EcuTek map switch instructions using rear defogger button:
Ignition on, engine off:
The driver can switch maps by turning on the rear window defogger switch while holding the accelerator to the floor. Every time you do this, the map increases by 1. After map 4, it goes back to map 1.
The check engine light will flash to indicate which mode has been set: One flash for map 1, two flashes for map 2, three flashes for map 3, etc.
Then start the car and drive!
- Bob
|
That's it! I wasn't pressing the accelerator.
Thanks