Quote:
Originally Posted by Mars2
I recieve my EUL JDL header beautifull part!!!!
But I have one question what tool do you use to screw the left and right screw's toward the center.
None of of my 14mm wrench can go their. The only one that is thin enough to pass in between the two tube is a 1/4 rachet with long extension but then the 1/4 14mm Socket is not deep enough to fully screw. 1/2 14mm is deep enough to screw fully the other 4 screws but the 1/2 shaft is to wide to pass in between the tube's. SO I have to go to tool shop to see if they sell Deep 14mm socket for 1/4 shaft. Or I will need spacer under those two screws.
Hos did you guy's manage that?
|
Different header, but I used a u-joint, deep socket and an extension on mine.