|
1. Pop out the 4 black push pin clips
2. Unhook the long clip at the bottom of the seat. It runs almost the length of the seat. Start on one side and work your way to the other side.
3. Each side is held in by 3 clips. While pulling on the them, use a small flat head screwdriver to pop them out.
4. Cut MLV to fit the seat.
5. Cuts holes in MLV to reinsert the clips. Dont' forget to cut the holes for the seat latches.
6. Use contact cement or spray adhesive to secure MLV to the seat frame.
7. Put seat back together and install in car.
|