Quote:
Originally Posted by zkv476
So I tried it with the PSI conversions (8.948 psia/V and +0.435 psia offset) and still threw a P0068  . The strange thing is it corresponds with the stock sensor on stock scaling... I recorded the atmospheric reading with engine off and got 14.65 psia and then started it, let it idle for 2 minutes and got the idle reading of 4.93 psia.
I then flashed the same map with the stock mapping and got the same values. I did drive around and let the ECU do some learning before taking the new values down. Any ideas or is it just a characteristic of a sensor with less fine intervals causing the code? |
wack this in your gogle search
"P0068 site:
www.ft86club.com"
also see here
http://www.ft86club.com/forums/showp...31&postcount=6
few people had problems with these onmi sensors
and some with vacuum leaks due no clamps on evap lines under intake manifold
might also be crook maf sensor
put oem back in to see if no codes thrown that should rule out vacuum leak
code related to correlation between maf sensor and throttle position