Thread
:
xDJ DUBx's Asphalt Rocket Bunny Monogram Series FRS Build
View Single Post
06-10-2014, 02:54 PM
#
156
xDJ DUBx
Lurker
Join Date: Jul 2013
Drives: '14 Rocket Bunny Monogram FRS
Location: High Desert, CA
Posts: 274
Thanks: 64
Thanked 152 Times in 95 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Group car wash with franz
Anyway onto the good stuff. Got my front wheels!
Now that was the test fit before I adjusted height, trimmed, cut etc etc. This is the final result.
Now I got a bit greedy because the front, even though fully maxed out, sat a little higher than the rear so last night I pulled the helper springs out for moar lowz
However that was a fat waste of time haha. The car actually sits higher now because I didn't want to lower the spring to the point where it had no preload. So since I refuse to run the coilovers set to where the spring will have "droop" I will be reinstalling the helper springs, accepting my finger gap and raising the rear accordingly to balance it out. Eventually I may invest in shorter front springs but for now, I will enjoy being able to toss the car around without damaging anything
Next up: Paint
__________________
Rocket Bunny Monogram Series
xDJ DUBx
View Public Profile
Send a private message to xDJ DUBx
Visit xDJ DUBx's homepage!
Find More Posts by xDJ DUBx