Quote:
Originally Posted by TM
I just ordered a Borla header and read through the DIY (great write up!).
What is the torque specifications for the o2 sensors? Do I need to put antisieze on them?
I'm guessing this is a no, since no one mentioned it, but do I need a new gasket for where I detach the frontpipe from the catback?
Last question, do I need the pass-through socket that is shown in the beginning? Where do I need to use it for?
Thanks for the write up!
|
I installed this header by myself too. Pretty straightforward.
I didn't torque the o2 sensor, just tightened it snug. Antiseize is a good idea.
It's always good practice to replace exhaust gakset, but I reused my front pipe to catback gasket. No problem.
I don't think I needed pass-through wrench/socket that was shown in the picture.
Good luck! Removing overpipe/front pipe piece from header was a bit challenging.