Quote:
Originally Posted by Maverick22
I have the stage 1 innovate supercharger setup. First off, I like the pull and have faith in my tuner, however I have some issues with my tune that I would like to find out if it is a typical effect of this particular kit.
I have a low end wall I hit just below 3k rpm in any gear that I have been told by my tuner is due to my lack of intercooler. I have not seen anyone else post about this with the stage 1 kit, so is this normal? litterally the car will be accelerating smoothly, then it will bog a little and then take off. It is frustrating because the car does not accelerate smoothly the way I expected the SC to or remotel close to the way it did stock.
I have another issue. I can no longer accelerate the same way I used to be able to in sixth gear. I would like to be able to. Literally the car bogs alot.
also my 6th gear cruise control is ony getting me 28mpg 
My tune has come a long way both on and off the dyno but I feel like it is just not hitting the mark. Does anyone else have these issues with the stage 1 kit? I am trying to determine if it is the kit or the tune just isnt there yet?
I am on 93 octane, have the stock pulley, and I am running an innovate lc1 that I am logging through my ecu via the second 02 sensor input, on ecutek.
Thanks in advance. |
I just upgraded to the innercooler setup, ran the the stg1 setup for about two months and I can say my very first tunes had a little of what you were describing but after a revision it was cleaned up. Who is your tuner?
Sent from my Nexus 5 using Tapatalk