Quote:
Originally Posted by ddeflyer
Yeah, maybe I shouldn't be calling it a tank slapper since that implies a much stronger and longer duration back and forth.
What I am referring to started well before I was to the berm. Specifically, a little after I passed the apex I added some steering input (I think I was trying to get myself back into the seat better and basically bumped the wheel as I tried to lever back into the seat) to the left. This brought the rear end out a little and the VSC activated. At this point it brought the rear back relative to the direction of travel or even slightly to the left. At this point I am just a foot or two from the berm, and either the tires just caught hold and pushed it back right or the VSC tried to damp the oscillation and started it going right again. Either way, the end result was that the rear stepped out that half foot or so needed to get off the berm and start the spin. All I knew at the time was that instead of a damping oscillation it just kept going. I went to straight but it was too little too late. I didn't even realize at the time that any tires had dropped until I saw the video.
|
Bottom line is, you were going too fast through that corner. The error was not realizing that soon enough. VSC on/off is irrelevant. If it was off, you would have spun as well and most likely sooner because you added steering input after going past the apex. You had to add steering input because the line you were driving was going to take you off course. Adding that steering input pushed the car into oversteer, your VSC probably stopped you from spinning out before you dropped a wheel. Once you dropped the wheel off, it was beyound what VSC could save.