Quote:
Originally Posted by aristo
Should check it once a while to make sure it does not start loosening on you
And to make the 12mm tightening much easier, you need to use a very short wrench (like less than 5 inches) to make sure it's grabbing correctly because there is not much room for positioning back there
|
My 12mm is short and I had room to move it, but still couldn't grab the bolt good enough.. anyways the drive is a lot smoother now, will keep an eye on the bolt. I am just scare that if I do adjustment again I will destroy the bolt because the 12mm slip on it when I turn. It was already like that when I unbolt it, but I still manage to loosen it.