Quote:
Originally Posted by daiheadjai
Here's what mine looks like.
Basically, each clip uses 2 screws:
Image 1 & 2:
The first screw holds the clip on your bumper (you can use a screwdriver to drive it in, but be careful of the placement), and passes the big hole through to the small hole (which is the side that will actually hold the clip to the bumper)
In the first 2 pics, you can see the back of the clip (which faces the rear of the car), where it is screwed into the soft black plastic of the rear bumper.
Attachment 76134
Attachment 76135
Image 3
The second screw is put in after you pull the diffuser edge over the long end of the clip (the diffuser tip has a little ridge that should slide right over the bracket/clip)
Attachment 76136
Image 4 & 5
These 2 pics give you and idea of the locations of the 2 screws
Attachment 76137
Attachment 76138
It should look something like this (pardon the crappy MS paint):
Attachment 76142 |
Thank you so much!! I really appreciate it!! Got it done thanks to you!
Sent from my iPhone using Tapatalk