[mav1178]

Originally Posted by Boostedpro

I don't know if you guys have tried this yet or not, but after I had new tails installed I ended up with condensation. So I popped the panel in the trinl and used a 1/4 inch ratchet with I think a 10mm socket and got probably an 1/8th of a turn on each nut. Haven't had any condensation since.

From TSB:

caution: Failure to follow the proper tightening sequence and torque specification will result in damage to the new combination lamp. Starting with number 1, hand tighten each nut in order prior to torquing them to the final specification. Torque the nuts down in the same order.
Torque Specification: 4.5 N-m (0.46 kgf-m, 39 in.lb)