Pics
I do not think I will do the reverse lights.
I got a test piece done for the front light housing. It came out aight so I'll do the others soon. I will just paint the inside with a little more resin to seal it completely. Then the obvious interior chrome and exterior flat black paint.
I wish the front wheels where flatter. The fronts look like my real rears, and the rears look mad offset yo. I had to throw in a fresh slammed picture too.
I still have to clean up the front grill area. Normally that area is left uncut, but I wanted the texture of the real thing. I will just leave a lip around the edge to glue my 1:10 space invaders grill too. the upper 4" (0.4" or 10mm) even has the backing. Sadly, I can't do anything about the front plate mount, so I'll just work around it.
I made the exact license plate this time too. I'll have "BITE ME" in the front, which is what I would have my real plate be if I was FI.
3D Toyota and piston badges for the win!
The exhaust is made of three pieces: two tips and well, the rest. I hope it fits. Most RC "exhausts" are only tips attached to the body. I wanted the piping, slash cut rolled tips, and the muffler though. Mine will also mount to the chassis instead of the body.
The wipers were modeled to scale: 20", 22", and modeled wiper arms.
The 2" Perrin shorty antenna is there too.
I think that's everything to date. I made a bunch of duplicates just so I can choose which part I like most or as a safety since these are really small.