Quote:
Originally Posted by SkAsphalt
The knee pads are "easier" than the doors because pulling off the door cards is kind of stressful and the handles are hard to get to pop off (So if you ever do get around to that, you certainly should get a plastic panel popper, something that wont scratch, but is firm enough to get in there)
Hardest part about the centre console was pushing out the accessory/USB tray from the center console (I pushed from the back with one hand, pulled from the front through the USB port hole) and getting the shiftier surround off (soft plastic panel popper is good here.)
This shows you all of the screws, locations, etc. |
Perfect timing! I'm getting my JPM knee pads, shift boot, hand brake boot, and gauge cluster in today. I'll be using these tips this weekend when I install them!
